Author Topic: HULME ATTACHMENT SCREW / BOLT  (Read 6075 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
HULME ATTACHMENT SCREW / BOLT
« on: June 14, 2011, 09:07:18 pm »
Can anyone Verify the thread of the Screw that attaches the Hulme case feeder to
the Star... :P :-[ ???

I show  '5/16"-24, is this correct......... ???
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

Rolling Stone

  • Active Members
  • ***
  • Posts: 76
    • View Profile
Re: HULME ATTACHMENT SCREW / BOLT
« Reply #1 on: June 14, 2011, 10:45:04 pm »
That's what the directions said to use.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: HULME ATTACHMENT SCREW / BOLT
« Reply #2 on: June 15, 2011, 03:44:51 pm »
After researching Drill sizes, I'm assuming that Hulme wanted a TIGHT thread
fit.......... :D
So I'll go with the 17/64" drill bit...........

Thanks everybody for the help.... ;D
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain