Author Topic: HULME BOLT  (Read 9477 times)

0 Members and 1 Guest are viewing this topic.

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
HULME BOLT
« on: October 18, 2011, 12:24:43 am »
Got one more Hulme to install, BUT, I need the Bolt to install it to the #12U Base.. :D
Anybody help me out.. ??? ??? ;D

It's  5/16"- 24 x 7/8"
« Last Edit: October 18, 2011, 06:29:18 pm by askimball (Doc) »
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

Lifetyme

  • Active Members
  • ***
  • Posts: 44
    • View Profile
Re: HULME BOLT
« Reply #1 on: October 18, 2011, 08:32:29 am »
Hi.

I'm sorry but I don't recall the bolt size offhand.  I have purchased them in the past from screw and bolt stores locally.  You might check your local yellow pages.

Regards,

Bob
Best Regards.

Bob

cc656d

  • Active Members
  • ***
  • Posts: 159
    • View Profile
Re: HULME BOLT
« Reply #2 on: October 18, 2011, 12:54:33 pm »
You might take one off of one of your tools and take it to the hardware. I am sure they can match it.
Distinguished pistol shot
2600 club
NIB Star
Benefactor member NRA
Life Member Va, Md, WVa, and Fl State Shooting Associations , Life OGCA

askimball (Doc)

  • Active Members
  • ***
  • Posts: 471
  • Cell - 318-518-0829 Central Time
    • View Profile
Re: HULME BOLT
« Reply #3 on: October 18, 2011, 06:33:04 pm »
OK, I'll do that......... :D

Thanks everybody......... ;)
Doc - I.Y.A.A.Y.A.S.
Retired Police Captain

rbwillnj

  • Global Moderator
  • ****
  • Posts: 1216
    • View Profile
    • Star Machine Works
Re: HULME BOLT
« Reply #4 on: October 19, 2011, 02:23:00 pm »
The bolt that attaches the Hulme to the reloader base has a 5/16-24 thread.   The length of the bolt depends on the style/vintage of the Hulme case feeder.   The most common Hulme uses a 2 1/2" long bolt.   The old style uses a 5/8" long bolt.   There is an intermediate style that looks like the newer ones, but has a large hole through the side (you sent me a picture of one).   I think this one also uses a 5/8" long bolt, but I'm not sure, and don't have one at this moment to check.
Star Machine Works
Star, the original blue Press.  Made by machinist, not machines.
www.StarMachineWorks.com

Marshal Kane

  • Active Members
  • ***
  • Posts: 21
    • View Profile
Re: HULME BOLT
« Reply #5 on: March 26, 2012, 04:11:43 pm »
. . .There is an intermediate style that looks like the newer ones, but has a large hole through the side (you sent me a picture of one).   I think this one also uses a 5/8" long bolt, but I'm not sure, and don't have one at this moment to check.
I have one and you are correct.  It is a 5/8" long bolt.