Author Topic: Safety taper die station  (Read 6268 times)

0 Members and 1 Guest are viewing this topic.

Big Earl

  • Active Members
  • ***
  • Posts: 10
    • View Profile
Safety taper die station
« on: June 07, 2013, 03:06:24 pm »
I have just set up for stuffing 45acp and on the tool head is a safety taper die.   My question is after the loaded and bullet seated round is moved to this station ( under the taper die ) the base of the cartridge in on top of the drop hole.
Am I missing something here?   What supports the cartridge when the tool head is lowered?  It also appears that he safety cam should be removed so the round can be extracted.   The outer edge on the cam makes cartridge removal difficult.    Knowledge greater than mine would be most appreciated.   Thanks!

Big Earl

varmintpopper

  • Active Members
  • ***
  • Posts: 299
    • View Profile
Re: Safety taper die station
« Reply #1 on: June 07, 2013, 03:45:13 pm »
Big Earl
When useing a taper crimp die You must have a solid plug that fills the hole in the last station. You may want to go
to the "for sale" section on this forum and and inquire if anyone has one for sale. they can also be manufactured by a
machinist. and we are very fortunate to have some top notch machinist as members.

Good Shooting

Lindy

Big Earl

  • Active Members
  • ***
  • Posts: 10
    • View Profile
Re: Safety taper die station
« Reply #2 on: June 08, 2013, 01:32:22 pm »
Just sent request to rbwillinj who said he had one.

Thanks.