Author Topic: Primer Slide Angle Lever  (Read 5730 times)

0 Members and 1 Guest are viewing this topic.

Sundance

  • Active Members
  • ***
  • Posts: 9
    • View Profile
Primer Slide Angle Lever
« on: July 09, 2013, 11:52:58 am »
Noticed that the Primer Slide Angle Lever #48 is getting worn.  Previous owner had this welded and then polished down.  I didn't think it should have worn that quickly.  I keep it greased lightly and dry graphite on the primer slide. Is this a case hardened part? Can I have it re-welded again without any problems?

varmintpopper

  • Active Members
  • ***
  • Posts: 299
    • View Profile
Re: Primer Slide Angle Lever
« Reply #1 on: July 09, 2013, 02:12:20 pm »
Sundance
I see no problem with welding a hard face weld on the angle lever and then grinding to proper dimensions, A skilled welder could do this.
You also may want to check the adjustment of the angle lever cam # 49/49U which can be bent in or out to align the primer slide so that it
doesn't bottom out with force against the coluum shaft causeing extra wear on the angle lever cam.
If You decide that a new angle lever is needed I have a new one that I could spare, If so, leave me a PM on this forum or send me an Email.

Good shooting

Lindy