Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jcw1970

Pages: 1
1
Stars Want to Sell/Want to Buy / WTS Moon Unit Indexer
« on: September 14, 2015, 10:55:11 pm »
Have an extra Ray-Vin Moon Unit Indexer that I've never used. $135 shipped to your door.

2
Looking for a Phelps 45 acp die set and shell plate. Also looking for a Brewster Indexer.

Thanks,

Jay

3
Star Reloaders / Holmes Reloading Products
« on: June 01, 2015, 10:02:06 pm »
Does anyone have any info on this company. I recently acquired 2 case tube feeders and was wondering if anyone out there had one also. Pretty simple design, a plastic base with a plastic bowl supported by 3 metal legs about 4 feet high. 5 plastic tubes attach to the bottom of the bowl and you fill the bowl and shake till you fill up the tubes.  Only problem I have is my reloading room is in the basement so the 4' tubes are a bit too long.

4
Star Lubricator & Resizers / Broke a Star!
« on: July 02, 2011, 09:31:38 pm »
Well I don't know how it happened but my sizer that I use 50/50 lube in died today. This was my oldest Star. I was lubing up some 38 wad cutters. I hadn't been straining or anything, they were going through fine, putting a lubed one in every 10 or so boolits. I ran out of lube, so I take it apart and put a new stick in, got everything back together, pulled the handle and it spit out a boolit with no lube, ok tighten up the plunger, pull the handle and again no lube. Get to looking and the fulcrum bar isn't even touching the pump plunger. Looking closer, the fulcrum lever bracket is almost cracked all the way down the bracket on the tube. Don't know how it happened. I only use this one for 50/50 and pistol bullets. I was sizing 356 to 3555. Looked at magma website and on the part drawing it says this is a factory only part. Any ideas out there? Any one got a parts sizer they want to part with?

Pages: 1