Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gunoil

Pages: 1
1
Star Lubricator & Resizers / Re: newbie, ordered delux lubesizer
« on: September 05, 2013, 12:52:25 pm »
Still stuck on hi tek bullets:
https://www.youtube.com/watch?v=sISgevoaTcUr

https://www.youtube.com/watch?v=sISgevoaTcUr

Iam putting a foot pedal system on my star sizer.

2
Star Lubricator & Resizers / Re: newbie, ordered delux lubesizer
« on: August 06, 2013, 03:15:53 pm »
i have 2 now and real happy, 1 for hi-tek-supercoat & 1 for blue stick regular.


Waiting on parts for right one.


Hope to have nose down mrbulletfeeder.net collator in 4 months.

Hi-tek-supercoat [no e-mail]@ my house. bayoubullets.net ,,, yea jerry miculek's brother donnie. Call him up, & talk to him about coatings and what color ya want.





harleykitplane.com                   [no e-mail]@.com   (my email)

3
Star Lubricator & Resizers / newbie, ordered delux lubesizer
« on: May 27, 2013, 04:40:21 pm »
Yep, a month ago, i ordered a delux lubesizer, most all accessories, Bout 800$.

Some things i need to make sure i have.

If ya know any more let me know here.
Magma star

catalog
die removal tool
slider & tube (9&45)
5/16 reversible pin vise
15" lube tube
hard blue lube only, no sticky stuff.

post below:

As Lathesmith mentioned the groove in the boolit  has to be centered with the lube holes. I pulled the die and inserted a "sized boolit" into the die and pushed it thru until I could feel the groove come into alignment with a "jewelers screwdriver"  inserted into the lube hole. I simple inserted the die into the machine and with the  [ "ram at its lowest point" ],  I adjusted the punch until it touched the bullet base. Guess what?

My thoughts: Max pressure, adjust with the PID control until the nose dots are gone, Let out the push rod a few turns and then adjust the boolit punch the correct height to allow for the "bounce" This should fix you problem.

I found that when I ordered dies from Lathesmith, I ordered top punches with locking nuts. Once adjusted properly, I keep the punches and the dies as a set. Changeover is a snap, no further adjustments required.

Pages: 1