Author Topic: WTT/WTB Anyone have 9mm dies and shellplate to trade for .45ACP dies/shellplate?  (Read 838 times)

0 Members and 1 Guest are viewing this topic.

Shumkles

  • Posts: 2
    • View Profile
I am new to this site.

I have 2 star loaders and one extra head. I have 2 sets of .45acp dies/shellplates and would like to trade one set for a 9mm setup.

I was thinking of getting Bruce to redrill one of the heads to use more common dies but I guess I would need the Shell plates from star for each caliber anyway.

Thanks

Shumkles


NYKenn

  • Active Members
  • ***
  • Posts: 428
  • Distinguished Pistol Shot
    • View Profile
    • The Firing Line
As 45 was the second most common caliber and 9mm was much rarer in quantity, and less common, the value is different and I doubt you will find many people willing to trade.

I know Rich Daniels (Barreltester) on this site make shell-plates, but I would also expect Bruce can supply both dies and plate and get you up and running quicker than re-drilling the head.

Unless you have already got it, you will also need the small primer bar, tube, and powder spout to accommodate 9mm, as well as powder measure for your load.

When I began to load .9mm, I went with an adjustable measure until I found my ideal load and then drilled a bar to that fixed powder drop.
Good luck!.
 
"A well regulated militia, being necessary to the security of a free state, the right of the people to keep and bear arms shall not be infringed"